SILENT INSTALL BUILDER REVIEWS SERIAL

ItвЂ™s important to not reboot after the installation is complete, as there are additional steps needed to ensure the new system will be able to use the serial console.

SILENT INSTALL BUILDER REVIEWS INSTALL

I was able to use the void-installer command to install Void Linux. From here, itвЂ™s just a standard x86_64 machine. Serial -speed=115200 -unit=0 -word=8 -parity=no -stop=1ДЄfter using dd to create a USB stick with this image, I was able to see Void loading up over the serial port. If youвЂ™re using a device that boots using UEFI and would like to see the GRUB screen over the serial port as well, you can add the following lines to grub/grub_ 3 prior to running mklive.sh: The FW-7541C is old enough that it only works in BIOS mode. In the following block, the console=ttyS0,115200n8 kernel parameter will open a boot console running at 115200 bps, with 8 bits and no parity (a common serial configuration). The build script takes a kernel command line option, which can be used to specify serial console options 2. This project does need to be run on a Void Linux system, as it runs several Void specific commands. Rather than attempt to modify the release image 1, I used the void-mklive project, which the Void team uses to make their installation images. However, the primary boot filesystem is non-modifiable (iso9660). Although the BIOS and PXE boot screens will show up over the serial port, bootloaders and the Linux kernel need additional configuration to route their input/output to a serial console.ДЄt first I thought I could mount the Void live USB image and modify the bootloader settings. Minicom is an open source serial client that will work with these adapters by running minicom -D /dev/ttyUSB0. This cable works with the standard ftdi_sio in the Linux kernel, and shows up as /dev/ttyUSB0. These types of serial connectors are common on a lot of networking equipment, and I was able to get a USB-to-RJ45 serial cable off of eBay for $13.77 (including shipping). Although the device comes with an RJ-45 to RS232 cable, none of my computers has a classic serial port. The serial port on this device comes in the form of an RJ-45 connector. It also goes through the post installation steps that will keep a login prompt active on the serial port after install.Д®Bay Listening for the Lanner FW-7541C-E01

This guide goes through building the installation media with the custom parameters needed for a serial console. It took some work, but I was able to setup and install Void Linux on this device using the serial port console. ItвЂ™s a well built little device I bought to replace my custom Linux router.

This industrial device has a 2-core/4-thread Atom D525 processor, a 30GB SATA SSD, 4GB of DDR3 ram and six independent Intel gigabit Ethernet adapters. I recently picked up a Lanner FW-7541C off eBay for $88.31 (including shipping).

Installing Void Linux with a Serial Terminal

Silent install builder reviews